Learn about ASTM A steel mechanical tubing and Atlas Tube’s manufacturing capabilities regarding this product for OEM applications. CALIFORNIA. Arrow Route. Rancho Cucamonga, CA WWW. ASTM A TUBING SPECIFICATIONS. TOLERANCES. ASTM A/AM: Standard Specification for Electric-Resistance-Welded Carbon and Alloy Steel Mechanical Tubing.

Author: Shakalkis Shazilkree
Country: Uganda
Language: English (Spanish)
Genre: Life
Published (Last): 16 December 2006
Pages: 339
PDF File Size: 3.26 Mb
ePub File Size: 14.1 Mb
ISBN: 192-3-35229-482-4
Downloads: 22649
Price: Free* [*Free Regsitration Required]
Uploader: Mura

Last previous edition approved in as A — 06b. Special Smooth Inside Surface S4. Your comments astn receive careful consideration at a meeting of the responsible technical committee, which you may attend.

A superscript epsilon e indicates an editorial change since the last revision or reapproval. No cracks or breaks in the base metal shall occur until the distance between the asrm is less than one third of the original outside diameter of the tubing, but in no case less than?

Disposition of such material shall be a matter for agreement. Since the sections are special, dies and other tools are not held available.

ASTM A Mechanical tubing VS ASTM A Mechanical tubing|SHEW-E

Work Item s – proposed revisions of this standard. The producer shall remove the transition material by an established procedure that positively separates the grades. Permissible variations in wall thickness for tubing made from hot-rolled steel are shown in Table 6.


Tubing furnished to this speci?

A Square Carbon Steel Tube | Alro Steel

Originally approved in Flash-In-Tubing is produced only to outside diameter tolerances and wall thickness tolerances and the inside diameter welding? Analyses of steels other than those listed are available.

D No Flash tubing is further processed by DOM for closer tolerances, produced to outside diameter and wall, inside diameter and wall, or outside diameter and inside diameter, with no dimensional indication of inside diameter?

Side leg of square to be equal to tube diameter except minimum length of 1 in. This condition is available in Types 1a, 1b, 2, 3, and 4.

Approved September 1, 1 Revised 3. A number in parentheses indicates the year of last reapproval. Evidence of lamination or burnt material shall not develop ast, the? Permissible Variations in Dimensions for Round Tubing 8. B Radius Tolerances, in. For grades of round tubing not shown in Table S5.

B Where the ellipsis Manufacturing practices limit the size range and section available from the various producers. B,C Outside Diameter, in. If secondary melting is employed, the heat shall be de? Permissible variations in wall thickness for round tubing, DOM for closer tolerances, are shown in Table 7. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters.


Up to 3, incl Over 3 to 43? E Flash Controlled to 0. D Flash Controlled to 0. Approved May 1, 1 Revised a531. Outside diameter burr to be removed for measurement. B Up to 21?

A513 Type 1 & 2 Tubing

Type Number 1a 1b 2 3 4 5 6? Hydrostatic Test Round Tubing S7. If the results of the mechanical tests do not conform to the requirements shown in the table, retests shall be adtm on additional tubes double the original number selected, each of which shall conform to the speci? Soft conversion applies to other SI measurements. Outside diameter 3 tolerances for cold-rolled steel tubing, sink drawn and DOM, are shown in Table 5.

Both retests for the elements in question shall meet the requirements of the speci?

This abstract is a brief summary of the referenced standard.